OBD II GPS Vehicle Tracker
OBD 2 Vehicle Tracker

OBD II GPS Vehicle Tracker
OBD II GPS Vehicle Tracker is a high-end GPS car tracker with international standard OBD II plug, which is specifically designed for the private and commercial vehicles. It’s easy to install, built-in backup battery, supports cut-off power alarm, acc detection, tracking location and upload fault diagnosis information and car condition in real time, widely applied to private cars and other motor vehicles with OBDII plug.
The following are parts of the type of the vehicles:
1. American gasoline vehicles sold after 1996; Chinese vehicles sold after 2003.
2. European vehicles sold in 2001 and produced in 2000; Diesel vehicle sold in 2004 and produced in 2003.
GPS + AGPS + LBS tracking
Multi-positioning function helps the drivers get a faster and more accurate location. When the device cannot receive the GPS signals, the GSM signals will switch to the LBS models to ensure that people can find their car at any time.
OBD II Remote Diagnosis
OBD II GPS Vehicle Tracker support remote diagnose the car’s condition, such as fuel consumption, water temperature, battery and voltage via OBD remote diagnosis system in real-time. Not only it helps you to know your car’s condition in real-time, but also it helps to optimize your driving habits.
Built-in Acceleration Sensor
With built-in acceleration sensor, OBD II GPS Vehicle Tracker can remote protect your car to be stolen. If someone moves your car without your consent, your phone will receive an alarm message and there is also an alarm notification in the tracking platform.
Widely Working Voltage
The working voltage range of GT230 is 9 – 36VDC, widely applied to the 12V/24V vehicle series.
Built-in monitoring CPU
Built-in monitoring CPU plays the watch dog function to reboot the device automatically after breakdown.
Installation: Once the OBD II connector has been located, all that is required is to plug the OBD II – GPS into the connector. Once you turn the ignition of the vehicle on, the small lights on the unit will blink. During your first installation, you will need to give the OBD II – GPS unit a minimum of 15 minutes fully initialize






GPS TRACKERS IN ON-BOARD DIAGNOSTIC SYSTEM IN CARS (OBD-II)
OBD II GPS Vehicle Tracker

Specification
Dimension: 64.5×50×27mm
Weight: 60g
Network: GSM/GPRS
Band: 850/900/1800/1900Mhz
GPS Sensitivity: -165dBm
GPS Accuracy: 5m
GPS Start Time
Cold status: 30s
Warm status: 11s
Hot status: 1s
Backup Battery: Chargeable changeable 3.7V 200mAh Polymer Li-Battery
Storage Temp.: -40C° to +85C°
Operation Temp.: -20C° to +70C°
Humidity: 5%–95% non-condensing
Note:
The technical specification and features can be changed without any prior notice.
The features described above may not be available in all version or may not be compatible with all vehicles.